Kickstarter Wizard miniAlley Instructions

• Remove Bubble Wrap and Blue Tape
• Remove the clips on the right window.
• Place Treasure Chest and Barrels as shown in picture below:

• Remove the top lid and place 4 AA Batteries. Close the top lid.
• Toggle the switch to turn on the light
• The extra wood panel is for customizing the shop window (see below)

* If you do not have any social platform, you can still join the contest by upload pictures here

If you would like to hang the custom Cauldron sign, please use instruction below. 

• Cut the existing sign hanging wire with a pair of scissors or any cutting tools. Remove the old signs.
• Put the metal wire through the hole in the new sign and twist it for about 1/2 in. 
• Hang the sign with the remaining wire. Twist the wire to secure the sign. Cut any extra wire.
  
  

If you would like to hang the custom Cauldron sign, please use instruction below. 

• Unscrew the 4 screws on the left panel. Don't lose the nuts and screws !!
• Gently pull the left panel out to the left direction. You will now have access to the traditional sign. 
  
• Cut the existing sign hanging wire with a pair of scissors or any cutting tools. Remove the old signs.
• Put the metal wires through the holes in the new sign and twist it for about 1/2 in.
• Hang the sign with the remaining wire. Twist the wire to secure the sign. Cut any extra wire
• Put the left panel back and tighten 4 screws. 

If you are looking to insert/remove items in the right shop window, you can follow instructions below. There is also a video at the end of this section.

• Remove the barrels under the window
• Unscrew the two screws on the right panel using a phillip screwdriver. 
  
  
  
  
• Gently pull the window to the left until it come off. If it stuck, check if the screw are completely loose. 
  
  
  
  
• Insert any new items that you would like. We also sent you a spare shop window panel if you would like to replace the existing one. Don't lose the nuts in the window!! You will need them to install the window later.
  
  
  
  
• Gently put the shop window back. Make sure the shop window edge is aligned with the vertical line on the wall. 
  
  
  
  
• Use a screwdriver to tighten the two screws on the right panel. If the screws can't be tighten, check if the shop window is aligned with the vertical line on the wall as shown in previous step. If it is still not tighten, check if the nuts in the window are still there. 

 

If you ordered a different top light, follow Instruction below to install the new light.

• Turn off the light switch.
• Remove the battery top lid.
• Unscrew the top light terminals using the provided screwdriver or any other compatible phillip screw driver
  
• Gently pull the old top light cable out of the terminals. Remove the lights
• Insert the new top light cable to the terminals. The positive cables are either brown or black with a red heat shrink at the end. Make sure it goes to the positive marked terminal. The unmarked black cable is negative. 
  
• Tighten the screws in the terminal. Gently pull on the cable to make sure you have a secure connection. If the cable came loose, reinstall the cable. 
• Route the new light through the top hole.